LED Dance Top

2 August 2015

I made Adam a LED dance top for his up-coming school dance.

I got of my ideas for this from

I cut some strips of paper that were the same size as the LED strip segments so Adam could create a pattern.

Then I cut the LED strips to length and laid it out.

After hot gluing the segments in place I started soldering wires to link up the segments.

Tested the first part.

I added a cheap RF LED controller to adjust brightness and flashing/pulsing rate. It's powered from three 18650 battery cells I pulled out of a long dead laptop - which should last a couple of hours.


He plans to wear this under his ninja costume - double awesome.

Page last modified on 07 August 2015 at 01:11 PM